[WaltherSathler]

Hallo zusammen,

nach der Installation der DVB-tbs Treiber funktioniert meine MCE Fernbedieung nicht mehr.
Es waren keine Einstellungen im Webif bei Konfiguration-Remote Control notwendig gewesen.

Wenn ich alles richtig verglichen habe, dann fehlen die Treiber für
 rc_rc6_mce
 mceusb

Wie kann ich diese nachträglich laden ?

Vor Installation waren diese vorhanden:

dmesg
..
Registered IR keymap rc-rc6-mce
input: Media Center Ed. eHome Infrared Remote Transceiver (147a:e042) as /devices/pci0000:00/0000:00:14.0/usb1/1-3/1-3:1.0/rc/rc0/input7
rc0: Media Center Ed. eHome Infrared Remote Transceiver (147a:e042) as
/devices/pci0000:00/0000:00:14.0/usb1/1-3/1-3:1.0/rc/rc0
IR RC6 protocol handler initialized
IR JVC protocol handler initialized
IR RC5(x/sz) protocol handler initialized
IR NEC protocol handler initialized
IR Sony protocol handler initialized
IR Sharp protocol handler initialized
IR MCE Keyboard/mouse protocol handler initialized
IR SANYO protocol handler initialized
input: MCE IR Keyboard/Mouse (mceusb) as /devices/virtual/input/input8
IR XMP protocol handler initialized
mceusb 1-3:1.0: Registered Formosa21 eHome Infrared Transceiver with mce emulator interface version 2
mceusb 1-3:1.0: 2 tx ports (0x0 cabled) and 2 rx sensors (0x1 active)
usbcore: registered new interface driver mceusb
r8169 0000:07:00.0 eth0: link down
r8169 0000:07:00.0 eth0: link down
IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
r8169 0000:07:00.0 eth0: link up
IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready

cat /proc/bus/input/devices
I: Bus=0003 Vendor=147a Product=e042 Version=1201
N: Name="Media Center Ed. eHome Infrared Remote Transceiver (147a:e042)"
P: Phys=usb-0000:00:14.0-3
S: Sysfs=/devices/pci0000:00/0000:00:14.0/usb1/1-3/1-3:1.0/rc/rc0/input7
U: Uniq=
H: Handlers=kbd event4
B: PROP=0
B: EV=100013
B: KEY=10000 4000000108fc310 22478d100000000 0 18c00 18040302801 8e168000000000 ffe
B: MSC=10

viele Grüße
Walther