Hi,
so, nun gibt's den nächsten Versuch mit dem DVB-Addon. Ich hab das nun so geändert, das es alle benötigten frontends erkennen und hinzufügen kann. Den Anderen Fehler habe ich noch nicht angegangen. Der kommt dann als nächstes, sofern der noch Probleme bereitet (oder überhaupt noch auftritt)
Ich warte auf Euren Bericht
Claus
Und hier der Bericht:
Nexus V2.3 + HVR-1300 + 20_MLD-1.9.0_dvb-0_47.tgz
Messages:
Nov 16 09:02:50 (none) syslog.info syslogd started: BusyBox v1.6.0
Nov 16 09:02:50 (none) user.notice kernel: klogd started: BusyBox v1.6.0 (2007-11-08 03:03:18 CET)
Nov 16 08:02:52 (none) user.warn kernel: firmware_class: disagrees about version of symbol struct_module
Nov 16 08:02:52 (none) user.warn kernel: bttv: Unknown symbol release_firmware
Nov 16 08:02:52 (none) user.warn kernel: bt878: Unknown symbol bttv_read_gpio
Nov 16 08:02:52 (none) user.warn kernel: bt878: Unknown symbol bttv_write_gpio
Nov 16 08:02:52 (none) user.warn kernel: bt878: Unknown symbol bttv_gpio_enable
Nov 16 08:02:52 (none) user.warn kernel: dvb_bt8xx: Unknown symbol bt878_stop
Nov 16 08:02:52 (none) user.warn kernel: dvb_bt8xx: Unknown symbol bt878
Nov 16 08:02:52 (none) user.info kernel: cx88/2: cx2388x MPEG-TS Driver Manager version 0.0.6 loaded
Nov 16 08:02:52 (none) user.info kernel: tveeprom 0-0050: Hauppauge model 96019, rev C6A0, serial# 543568
Nov 16 08:02:52 (none) user.info kernel: tveeprom 0-0050: MAC address is 00-0D-FE-08-4B-50
Nov 16 08:02:52 (none) user.info kernel: tveeprom 0-0050: tuner model is Philips FMD1216ME (idx 100, type 63)
Nov 16 08:02:52 (none) user.info kernel: tveeprom 0-0050: TV standards PAL(B/G) PAL(I) SECAM(L/L') PAL(D/D1/K) ATSC/DVB Digital (eeprom 0xf4)
Nov 16 08:02:52 (none) user.info kernel: tveeprom 0-0050: audio processor is CX882 (idx 33)
Nov 16 08:02:52 (none) user.info kernel: tveeprom 0-0050: decoder processor is CX882 (idx 25)
Nov 16 08:02:52 (none) user.info kernel: tveeprom 0-0050: has radio, has IR receiver, has IR transmitter
Nov 16 08:02:52 (none) user.info kernel: cx88[0]: hauppauge eeprom: model=96019
Nov 16 08:02:52 (none) user.info kernel: ACPI: PCI Interrupt 0000:00:14.2[A] -> Link [LNKB] -> GSI 10 (level, low) -> IRQ 10
Nov 16 08:02:52 (none) user.info kernel: cx88[0]/2: found at 0000:00:14.2, rev: 5, irq: 10, latency: 32, mmio: 0xf8000000
Nov 16 08:02:52 (none) user.info kernel: cx88[0]/2: cx2388x based DVB/ATSC card
Nov 16 08:02:52 (none) user.info kernel: DVB: registering new adapter (cx88[0])
Nov 16 08:02:56 (none) user.err vdr: [1161] ERROR: no OSD provider available - using dummy OSD!
root:dmesg | grep -i dvb
dvb_ttpci: Unknown symbol release_firmware
dvb_ttpci: Unknown symbol request_firmware
saa7146: register extension 'budget dvb'.
saa7146: register extension 'budget_patch dvb'.
dvb_bt8xx: Unknown symbol bt878_num
dvb_bt8xx: Unknown symbol bttv_sub_unregister
dvb_bt8xx: Unknown symbol request_firmware
dvb_bt8xx: Unknown symbol bttv_write_gpio
dvb_bt8xx: Unknown symbol bttv_sub_register
dvb_bt8xx: Unknown symbol bttv_get_pcidev
dvb_bt8xx: Unknown symbol bt878_start
dvb_bt8xx: Unknown symbol bttv_gpio_enable
dvb_bt8xx: Unknown symbol bt878_stop
dvb_bt8xx: Unknown symbol bt878
cx88[0]: subsystem: 0070:9601, board: Hauppauge WinTV-HVR1300 DVB-T/Hybrid MPEG Encoder [card=56,autodetected]
tveeprom 0-0050: TV standards PAL(B/G) PAL(I) SECAM(L/L') PAL(D/D1/K) ATSC/DVB Digital (eeprom 0xf4)
cx88/2: cx2388x dvb driver version 0.0.6 loaded
cx88/2: registering cx8802 driver, type: dvb access: shared
cx88[0]/2: subsystem: 0070:9601, board: Hauppauge WinTV-HVR1300 DVB-T/Hybrid MPEG Encoder [card=56]
cx88[0]/2: cx2388x based DVB/ATSC card
DVB: registering new adapter (cx88[0])
DVB: registering frontend 0 (Conexant CX22702 DVB-T)...